SX-200 ICP 3.0 or 4.0 software

[Curtin_BPW]

Does anyone have 3.0 or 4.0 software they can PM over? Mitel has taken down so much legacy documentation and software.

[acejavelin]

Why wouldn't you just use the latest 5.0 that is available on the site?

The software key works from 4.0 for sure, probably 3.0 as well.

[Curtin_BPW]

I am nervous to jump so many major release at once

[acejavelin]

I am nervous to jump so many major release at once

Fair, but check the technicians handbook or the latest release notes, I think you can from 2.X all the way to 5, but not from 1.X.

[Curtin_BPW]

Yeah I found documentation that local upgrade via CF and is supported (FTP upgrade is not supported for 2.0 to 5.0). I have a SX-200 MX Controller that I pulled off the shelf in my office that would not boot that was found in a recycling pile, diagnosed it, pulled a DSP card out of the MMC slot, and got it to boot! I want clone the drive and then practice a local software upgrade on it via CF before heading to the field to do this.

I then want to though the original drive with older software/licensing back in and use it in my lab in the office for testing things. Does anyone know of a backdoor way to reset a SX-200 password without going through support. I have read this is possible on the 3300. Not worth spending the money to get SX-200 certified at this point with it just getting announced to be EOL (certified in 3300 and 470) and want to use it as a lab system.

[acejavelin]

To my knowledge, the SX200 cannot have the password reset without support... I haven't found a backdoor or anything to get in. The best you can do is a new CF from Mitel and start clean, it might even be cheaper, not sure as I haven't had a password reset done a 200 for many years.