Attaching a pstn line to a 3300

[mortcars]

I want to connect a BT pstn line to the mitel 3300 so I can route the inbound pstn call into our system.

I'm assuming I should be able to do this using the on board AMB using one of the 5 analogue LS ports on the back of a controller

Am I correct in thinking this? its been a long time since i've had to do anything analog

from memory if im correct i need to set CO trunk circuit description > analog trunks and trunk attributes but im fuzzy on the detail

any help would be muchly appreciated

[acejavelin]

You are correct... the process is in the embedded help system.

[mortcars]

What ive done so far

Connected the pstn to the ONSp 2 port on the rear of a controller

Configured trunk attributes form
Service #9
Cos #65
Cor #8
Baud#300
Intercept #1
Non-dial in trunk answer point- day #83661
Non-dial in trunk answer point- night 1 #83661
Non-dial in trunk answer point- night 2 #83661
Trunk label #gcc test

Analogue Trunk Form
Cab #10
Shelf #1
Slot #1
Circuit #6
Card type #hybrid 4 ons 6 ls
Trunk number #1001
Trunk service number #9
Circuit descriptor #2
Interconnect #1
Tenant #1

How does that all look?

I need to be able to route the incoming call from this line to my phone, what am I missing

Ta

[billbry66]

Ons is for analog handsets

you should be connecting atrunk to teh LS ports

there are 4 ons and 6 ls on a mainboard