Mitel Forums > Mitel MiVoice Business/MCD/3300

questions on APC card overheating and server-gateway setup

<< < (2/2)

Northeaster:
Any input into which ports to open up on the APC firewall, to allow basic internet access would be appreciated!!  I am not too worried about security at this point, as this is not a customer switch!!  The APC card is still up, and running!!

Northeaster:
Well, the APC card ran for about a week, with only one of the two heat dissapaiting patches (cut in half, with half on each spot) .
Then, I found the other patch, so I took the card off, installed both patches, and of course, the card now seems to overheat / shut off again.  I will try splitting one patch, as before, to see if it works, but i shouldn't have to do that!!

I would like to hear if anyone else has experienced heat / shutting off issues with the APC cards!! 

I don't get the message "reached critical temperature - shutting down" now, as that was during telnet sessions, to do initial install.

Now, while logged into server-manager, with internet explorer, if I try to reinstall a blade, or upgrade my MSL version, I loose connection to the APC card after the counter says I am about 20% done the final install step!!  I cannot ping the card, or of course, use explorer or telnet, until I unplug the 3300, and let it boot up again (I assume the APC cools off during this break)

Navigation

[0] Message Index

[*] Previous page