Vlan with two servers

[ianbt001]

I need advise, I am setting up a new system with an HP Procurve, I have set up two vlans one for the data and one for voice. I am using the Mitel built in server on vlan 2 and the customers data server on vlan 1. I have set up the tagging on the procurve and basically the ip phone will go to the default vlan 1 and option 125 will then point it to the voice vlan 2, this works OK, The handsets boot up OK. If i connect to the back of the handset I can surf the internet BUT I cannot browse to the Mitel system.
If I set a static address on my laptop and a gateway address then I can access the Mitel system but cannot surf the net.

Mitel System ip  192.168.1.2

HP 192.168.0.1

Customers Network is on 192.168.0 XXX

Gateway  192.168.0.200

Voice vlan 2 is on 192.168.1.200

Data vlan is 192.168.0.200

I can ping from Mitel system to 192.168.1.200.

Any idea's or advice welcome.


  

[bluewhite4]

If you do a route trace from a voice ip address to a data ip address, what path does it take?

[ralph]

My guess would be that you don't have anything routing between the VLANS. 
What are you using for a router?

Ralph

[bobcheese]

I'm with Ralph on this one. As your Data is on VLAN 1 and voice is on VLAN 2 you will need soemthing to route between the two VLAN's. A router with an uplink from both VLAN's onto the switch (or a trunk port with sub-interfaces depending on your router) is required. Eitherway something that can route from 192.168.0.xxx to 192.168.1.xxx. Depending on your model of procurve switch, it may be able to do the routing as some are layer 3 with routing capabilities.

[ianbt001]

Its a procurve 2610 which I thought and I had turned the routing on but it still does not work.

[ralph]

I found a link here on another forum that may be relevant.
It's a bit much for me to reiterate so check out the link and let us know if that was it.
forums.whirlpool.net.au/archive/1150763

Ralph

[Chakara]

  The 2610 can do the routing - probably your easiest fix.  You'd need to make it the default gateway for both subnets and turn on IP Routing.

-Chak