Mitel 430 setup

[bojo387]

Not sure about the routing but your line seems to be down. Your sync state is "hold". Is the line working? By default, any incoming call will reach user group 16 unless that routing was removed.

[gpais70]

Not sure about the routing but your line seems to be down. Your sync state is "hold". Is the line working? By default, any incoming call will reach user group 16 unless that routing was removed.

Hi

See the picture below the state changes dinamicaly to hold after a lapse of time.

On you route and call distribution wich is sequence as cde, swt po1,  etc?

Regards

Enviado do meu ALE-L21 através do Tapatalk

[bojo387]

Could you share a screenshot of your incoming and outgoing routing with the arrows to and from your trunk? You could black out any confidential numbers.

 

[gpais70]

Could you share a screenshot of your incoming and outgoing routing with the arrows to and from your trunk? You could black out any confidential numbers.

Hi

Please see the pictures.
Let me know step by step what to do on route.
Regards

Enviado do meu ALE-L21 através do Tapatalk

[gpais70]

Could you share a screenshot of your incoming and outgoing routing with the arrows to and from your trunk? You could black out any confidential numbers.

Hi

Please see the pictures.
Let me know step by step what to do on route.
Regards

Enviado do meu ALE-L21 através do Tapatalk

New config.
Please check outogoing calls and what is wrong.

Regards

Enviado do meu ALE-L21 através do Tapatalk

[bojo387]

1. As I understand, your exchange line is physically connected to port 1.1
2. I assume your default outgoing route for users is route 1 based on your photo.

Your latest photo shows there is no allocated trunk group for route 1. You should allocate trunk group 1 (ADMIN) which are your BRI ports.

When your users dial the exchange access, it will go via route 1--> trunk group 1--> 1.2 then 1.1.
If you are not using 1.2, double-click on it under Network Interfaces and tick outgoing barred... so it is not included in the hunt for an outside line.

[gpais70]

1. As I understand, your exchange line is physically connected to port 1.1
2. I assume your default outgoing route for users is route 1 based on your photo.

Your latest photo shows there is no allocated trunk group for route 1. You should allocate trunk group 1 (ADMIN) which are your BRI ports.

When your users dial the exchange access, it will go via route 1--> trunk group 1--> 1.2 then 1.1.
If you are not using 1.2, double-click on it under Network Interfaces and tick outgoing barred... so it is not included in the hunt for an outside line.

Hi Bojo

Now i can call out but the sinchronization still on hold.

See the pictures below.
 
Regards

Enviado do meu ALE-L21 através do Tapatalk

[gpais70]

Speed Dialing Aastra 430

Hi

Would like to know how can proceed with programing speed dialing only for internally calls on phones 6863i 58xx.
Our extensions starts with 1000-1007.

Best regards

Enviado do meu ALE-L21 através do Tapatalk