Author Topic: How to remove resilency off 5330 phones  (Read 1288 times)

Offline rlafata

  • Jr. Member
  • **
  • Posts: 63
  • Karma: +0/-0
    • View Profile
How to remove resilency off 5330 phones
« on: May 01, 2018, 02:21:34 PM »
We shut down a location that has about 15 5530 IP phones off a 3300.  I deleted the phones off the controller before it was shutdown.   Now when I boot up the phones it boots off the resilient controller.  How can I remove these resilient phones off the resilient 3300?   Running software 7.0.


Offline sarond

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1405
  • Country: au
  • Karma: +73/-0
    • View Profile
Re: How to remove resilency off 5330 phones
« Reply #1 on: May 01, 2018, 07:30:05 PM »
I am going to assume MCD 7.0 (14.0.x.x) not release 7

Did you remove the controller from the cluster?

First thing I would try is "GDM CHECK USERANDSERVICE" and "GDM REPAIR USERANDSERVICE" from maintenance commands.

Offline VinceWhirlwind

  • Hero Member
  • *****
  • Posts: 899
  • Country: au
  • Karma: +31/-0
    • View Profile
Re: How to remove resilency off 5330 phones
« Reply #2 on: May 01, 2018, 07:39:41 PM »
If both controllers are still clustered you could try to force a sync with "overwrite" onto the secondary controller.
Take backups first in case something bad happens.

Offline rlafata

  • Jr. Member
  • **
  • Posts: 63
  • Karma: +0/-0
    • View Profile
Re: How to remove resilency off 5330 phones
« Reply #3 on: May 02, 2018, 02:44:15 PM »
I am on version 7.0 SP1 PR2  load 13.0.1.53   The GDM check did not find anything.  I'm reluctant to remove cluster due to it may cause other issues.  My vendor tells me I have to rebuild the phones then remove resiliency and then delete the phones.   Why did it allow me to remove the phones with resiliency in the first place!

Offline VinceWhirlwind

  • Hero Member
  • *****
  • Posts: 899
  • Country: au
  • Karma: +31/-0
    • View Profile
Re: How to remove resilency off 5330 phones
« Reply #4 on: May 02, 2018, 06:56:04 PM »
Check your SDS errors - when you delete a resilient set, it should of course remove it from both primary and secondary. If that hasn't happened, it must be that the sync failed.

Offline rlafata

  • Jr. Member
  • **
  • Posts: 63
  • Karma: +0/-0
    • View Profile
Re: How to remove resilency off 5330 phones
« Reply #5 on: May 03, 2018, 11:05:29 AM »
I see the SDS distribution errors on the system.  The Force Change is grayed out.  Any idea on how to force the change?

Offline rlafata

  • Jr. Member
  • **
  • Posts: 63
  • Karma: +0/-0
    • View Profile
Re: How to remove resilency off 5330 phones
« Reply #6 on: May 10, 2018, 10:47:07 AM »
My vendor removed the decommissioned control in the cluster to free up IP phones.


 

Sitemap 1 2 3 4 5 6 7 8 9 10