Mitel Forums > Mitel MiVoice Business/MCD/3300

Mitel 3300ICP

(1/1)

ramjimh:
We are using Mitel 3300 ICP controller.We r using mitel 5212 phones.we get network from output of phone.We need to convert an Ip line to analog line.We r using Cisco ATA 186 to convert from ip to analog.i am getting the dial tone from the output of cisco ata186,but i cannot able to make outgoing calls.Need config for ATA186 that supports mitel.

the firmware version of cisco ata186 is 3.2.1sip. Need solution


With Regards,

Ramji

ralph:
This is something I've always wanted to test but never had the opportunity.
I am assuming you are using SIP.   
Can you call an internal extension.  If yes, then the problem is either with your COS (check the Public Network connections) or COR (be sure it has a COR that allows it to dial out) or interconnect (be sure you are not blocking from other turnks.)

If you can't dial internal extensions, then check your SIP programming a little closer.

Ralph

Navigation

[0] Message Index