Home Page Articles User Guides News Letter  



Author Topic: Device is not man-busied  (Read 5480 times)

Offline doctora

  • Jr. Member
  • **
  • Posts: 67
  • Karma: +0/-0
    • View Profile
Device is not man-busied
« on: August 23, 2010, 09:29:28 PM »
I have a bad port on an analog card.  I am unable to replace the card for a couple weeks but in the mean time I want to move the user to another card.  I tried to delete the user so I could build them back up on another card but when I go to delete the selected user I get the message "Device is not man-busied".

Thanks for the help
Mark


Offline v2win

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 599
  • Country: us
  • Karma: +9/-0
    • View Profile
Re: Device is not man-busied
« Reply #1 on: August 23, 2010, 10:54:43 PM »
go into maintenance and type busy <insert your plid here>

Offline doctora

  • Jr. Member
  • **
  • Posts: 67
  • Karma: +0/-0
    • View Profile
Re: Device is not man-busied
« Reply #2 on: August 24, 2010, 08:58:15 AM »
The response is "Non-unique match"

Offline wobbly_head_bob

  • Jr. Member
  • **
  • Posts: 56
  • Karma: +0/-0
    • View Profile
Re: Device is not man-busied
« Reply #3 on: August 25, 2010, 09:05:12 AM »
You should be able to delete an analog port without having to busy it out first...is this an onboard analog or is this an ONS card in a pnode?  Also, if you're seeing "non-unique match" then something is likely wrong with how you're inputting the PLID number.

Try this:

Go into Maintenance Commands and enter: LOCATE EXTENSION XXXX (XXXX represents your trouble extension)

The read out should like similar to:

Card Type : On Premises Line                                                   
Circuit Location : X X X XX                                                     
Extension : XXXX

Now enter:  BUSY X X X XX (this will be the "circuit location" identified above)

 

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5297
  • Country: us
  • Karma: +453/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Device is not man-busied
« Reply #4 on: August 25, 2010, 12:21:31 PM »
You only need to man busy trunks.  Devices will delete ok.

The message that says "non-unique match" means the pbx is expecting an answer from you and it's not getting what it's expecting. 
In your case, since you're trying to busy out a trunk, it's waiting for you to enter "force". 
Try than and you should be just fine.

Ralph
« Last Edit: April 23, 2014, 02:07:20 PM by ralph »


 

Sitemap 1 2 3 4 5 6 7 8 9