Home Page Articles User Guides News Letter  



Author Topic: Mitel Teleworker Event Log -loss of rx stream from IS for 5020ms-  (Read 6219 times)

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5297
  • Country: us
  • Karma: +453/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Getting one way audio.
My Teleworker event logs show this:
"loss of rx stream from IS for 5020ms"

Does the 'IS' stand for "ICP Side"?
and conversely does "SS" stand for "Set Side"?
"loss of rx stream from IS for 5020ms"

Ralph
« Last Edit: February 17, 2012, 08:42:19 AM by ralph »


Offline martyn

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 683
  • Country: au
  • Karma: +10/-0
    • View Profile
Re: Mitel Teleworker Event Log -loss of rx stream from IS for 5020ms-
« Reply #1 on: February 20, 2012, 05:09:00 PM »
One would assume so! I couldn't find anything in the engineering guide or anything covering that, but I would say that it's a fair assumption.

5 seconds is a long time for a loss of stream, so I would say that the call would fail in that time.

If you run the TNA tool is there much latency or jitter? Is the one way voice only momentary or for all of the call?

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5297
  • Country: us
  • Karma: +453/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Mitel Teleworker Event Log -loss of rx stream from IS for 5020ms-
« Reply #2 on: February 20, 2012, 10:25:13 PM »
Got it sorted.   
I was just confused about what the "IS" and "SS" stood for.
In the end it was what I suspected.   Customer made a change in their firewall that caused the issue.
There was only one way audio. 

Ralph


 

Sitemap 1 2 3 4 5 6 7 8 9