Author Topic: 5000 HX w/ 5360 IP phones (resetting)  (Read 4461 times)

Offline gjmoran

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
5000 HX w/ 5360 IP phones (resetting)
« on: March 01, 2011, 11:50:27 AM »
I get an occasional reset during the day on all of the phones at one of my customer sites. The phones will show 'Loading Application...' then reboot. This happens at random times and I can not for the life of me figure it out. Has anyone else had this issue? If so, what was the resolution?

Thanks


Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5739
  • Country: us
  • Karma: +468/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: 5000 HX w/ 5360 IP phones (resetting)
« Reply #1 on: March 01, 2011, 04:08:13 PM »
I've seen this.
Is it happening only when someone is transferring the call?

The fix in our case was to turn off ICMP redirects in the routers.

Ralph
« Last Edit: April 23, 2014, 01:18:37 PM by ralph »

Offline gjmoran

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: 5000 HX w/ 5360 IP phones (resetting)
« Reply #2 on: March 03, 2011, 01:37:29 PM »
i will check it out and let you know. thanks for the advice.

Offline greg138

  • New Member
  • *
  • Posts: 3
  • Karma: +1/-0
    • View Profile
Re: 5000 HX w/ 5360 IP phones (resetting)
« Reply #3 on: March 17, 2011, 06:32:30 PM »
I have seen this at a customer's site who was running a network mapping software which essentially created a DOS condition on the phone, on a side note only the 5360's were effected not the 5320's. We ran a packet capture using the mirrored port option on the phone and found it to be related to the software probing port 5060 with Sip messages. The monitor would refresh every two hours which would in return reset the phones every two hours.

Offline mav

  • Jr. Member
  • **
  • Posts: 60
  • Country: england
  • Karma: +0/-0
    • View Profile
Re: 5000 HX w/ 5360 IP phones (resetting)
« Reply #4 on: June 03, 2011, 02:31:17 PM »
Make sure if you are using a PoE that the switch offers sufficient power to all ports not just say half of them. 5360 draws more power that 5324's etc


 

Sitemap 1 2 3 4 5 6 7 8 9 10