Show Posts
1
Mitel MiVoice Business/MCD/3300 / Mitel 3300 CXi RS232 cannot input
« on: September 07, 2017, 12:36:43 PM »
I have a 3300 CXi that's having some network issue. I am trying to correct it's IP using the RS232 port documented in the manual.
Using Hyperterminal, putty, and termite, I can see output from the CXi. However, I am unable to input anything. I followed the setting outlined by the document :
- Baud Rate: 9600
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
I have also connected
I see the message
"The communication program will instruct you to Press <SPACE><SPACE><SPACE> to stop auto-boot AFTER countdown starts"
and nothing happens when I press <space>.
Any help would be greatly appreciated.
Using Hyperterminal, putty, and termite, I can see output from the CXi. However, I am unable to input anything. I followed the setting outlined by the document :
- Baud Rate: 9600
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
I have also connected
I see the message
"The communication program will instruct you to Press <SPACE><SPACE><SPACE> to stop auto-boot AFTER countdown starts"
and nothing happens when I press <space>.
Any help would be greatly appreciated.