Messages

1

Mitel MiVoice Business/MCD/3300 / Re: Analog MWL

« on: August 16, 2022, 03:42:29 PM »

I think it was a combination of analog descriptor settings and COS settings

Did u remember the settings. I have message waiting enabled under analog descriptor and COS settings but lamp is not turning on.

2

Mitel SX200, SX2000, and older SX platforms / Re: SX200 ELx - Message Waiting not working on Analog Sets.

« on: August 11, 2022, 03:48:09 AM »

A hotel changed all there analog room phones to a Cetis type phone,  they are sure the MWI was working after the set change and now no MWI on analog sets.

There are 5 per bays and no MWI on any of them,  the Ringing LED on the Power supply should be flashing when a phones lamp is lit and the LED is not flashing on any of the Power supplies.

One of the power supplies has been replaced and no Ringing LED on it either.

Were you able to find the solution. I am facing similary issue. MWL is not turning on on Cetis phones.

3

Mitel MiVoice Business/MCD/3300 / Re: Analog MWL

« on: August 11, 2022, 03:21:19 AM »

Any update on the above issue. I am also facing similary issue.

4

Mitel MiVoice Business/MCD/3300 / View errors with dbms check on New Installation

« on: July 04, 2022, 05:40:51 AM »

Hi All,
Please applogies me for my igrnorance as i am new to the Forumn and Mitel. I am in process of commissioning my first AX controller. I have installed Mivb v9.4 and after the installation i am getting 11 view errors when running the DBMS check.
I tried to run DBMS check full couple of times but it didn't help. This is new installation with no configuration or Licences installated on the system.
Please guide me how I can fix the issue.

Thanks,