Mitel Forums - The Unofficial Source

Mitel Forums => Mitel SX200, SX2000, and older SX platforms => Topic started by: SXTech on September 07, 2017, 12:24:06 PM

Title: SX-200 AX
Post by: SXTech on September 07, 2017, 12:24:06 PM

Just got an SX-200 AX and it does not get past auto-boot.
The parameters look correct and I tried to follow the THB, but no luck.
I installed the 4gig CF in Slot 1 and there in nothing in slot 2
What am I missing?

Title: Re: SX-200 AX
Post by: acejavelin on September 07, 2017, 01:19:44 PM

Slot 1 is for upgrades, and slot 2 is the system CF, move the compact flash to slot 2 (under MMC1, the lower slot on the card) and it should boot up fine.

Title: Re: SX-200 AX
Post by: SXTech on September 07, 2017, 01:31:55 PM

Thank you Ace.
I moved the CF to slot 2 and now it says can't load boot file.

Title: Re: SX-200 AX
Post by: acejavelin on September 07, 2017, 01:33:17 PM

Quote from: SXTech on September 07, 2017, 01:31:55 PM

Thank you Ace.
I moved the CF to slot 2 and now it says can't load boot file.

It should definitely be in Slot 2, sounds like a bad/corrupt CF card.

Title: Re: SX-200 AX
Post by: SXTech on September 07, 2017, 01:37:17 PM

I will try to reburn the software on the CF and let you know what happens.
Appreciate your input.

Title: Re: SX-200 AX
Post by: SXTech on September 07, 2017, 04:03:57 PM

It's all good, got it going.
Thanks again.