« previous next »
Pages: [1]   Go Down

Author Topic: Boot process  (Read 2717 times)

Offline Fergus

  • Contributer
  • *
  • Posts: 9
  • Country: us
  • Karma: +0/-0
    • View Profile
Boot process
« on: February 11, 2015, 02:48:24 PM »
Is there a way on the 5000 HX to watch the boot up process other than what is shown on the display?

We recently too our demo system to a customer for a demonstration and now it won't boot up all the way. You see all the processes starting, then they show stopping. Eventually the whole process starts over again. Tried reseating the main card and the flash card but it didn't help.  I would like to see if we can determine exactly where the boot process fails.

thanks
Logged

Offline 619Tech

  • Global Moderator
  • Sr. Member
  • *****
  • Posts: 230
  • Country: us
  • Karma: +1/-0
    • View Profile
Re: Boot process
« Reply #1 on: February 11, 2015, 06:28:03 PM »
Connect to the USB-B connector on the front of the HX/IT5K. I connect via PuTTy (Serial to COM port), 115200.
Logged

Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2983
  • Country: us
  • Karma: +89/-1
    • View Profile
Re: Boot process
« Reply #2 on: February 12, 2015, 07:09:37 AM »
Fergus,

Don't forget to run the USB to Serial utility that is within the installation directory for your 5000 software so you can use the USB A to USB B connection to see what is going on.


Good Luck,

TE

Logged

Offline Fergus

  • Contributer
  • *
  • Posts: 9
  • Country: us
  • Karma: +0/-0
    • View Profile
Re: Boot process
« Reply #3 on: February 12, 2015, 09:58:46 AM »
Thank you both for the information. I'll give it try!
Logged

Offline Fergus

  • Contributer
  • *
  • Posts: 9
  • Country: us
  • Karma: +0/-0
    • View Profile
Re: Boot process
« Reply #4 on: February 16, 2015, 04:00:20 PM »
Just as an update, it was the flash card that was bad.

Haven't attempted to connect to the USB-B port yet - didn't have the correct cable

Should have one here in a couple of days and will try it then
Logged

Offline unclejemima

  • Full Member
  • ***
  • Posts: 165
  • Country: ca
  • Karma: +0/-0
    • View Profile
Re: Boot process
« Reply #5 on: February 17, 2015, 04:49:47 PM »
Sounds like you have the same problem I'm having. 

http://mitelforums.com/forum/index.php?topic=6447.0

Just curious how you fixed the sd card?  Did you find a new one and reload on the last good config?

I'm not sure what to do with mine and was wondering how you made out.
Logged

Offline Fergus

  • Contributer
  • *
  • Posts: 9
  • Country: us
  • Karma: +0/-0
    • View Profile
Re: Boot process
« Reply #6 on: February 23, 2015, 12:18:03 PM »
We had to get a new flash card, license it, and load the database
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10